• 1.800.860.6272
  • Shopping Cart

    There are 0 items in your cart.

    You have no items in your shopping cart.

    Cart Subtotal: $0.00

    Home / Science projects / Balloon Hovercraft
    • Balloon Hovercraft

      Balloon Hovercraft

      Try this very simple project to create a floating disc that skims across a surface similar to the way an air hockey puck or hovercraft does.

      What You Need:

      • Blank CD or CD you don't want any more.
      • Pop-top cap from a water bottle or dish soap bottle
      • Balloon
      • Hot glue gun

      What You Do:

      1. Use the hot glue gun to carefully glue the bottle cap over the center hole of the CD and let it set. Make sure the edges are fully sealed.
      2. Push the pop-top cap closed. Blow up the balloon, then hold it so that no air escapes, but don't tie it off. Stretch the mouth of the balloon over the bottle cap (you may need an assistant to help you do this so that you don't lose any air from the balloon). Now adjust the balloon so that it stands up straight and centered.
      3. Set the hovercraft on a hard, smooth table and open the pop-top; then nudge the device along and see what happens.

      What Happened:

      A hovercraft works by forcing air out beneath it, creating a cushion of air to float on. Hovercrafts usually have a "skirt" that surrounds the base to contain the air; in this project the CD is light enough that it doesn't need a large cushion, so no skirt is necessary. The balloon acts as a pressurized gas chamber. When you open the cap, the balloon forces air out through the cap, creating a thin cushion of air beneath the CD.

      As you nudged your hovercraft around, you may have noticed that it zipped along the surface like an air hockey puck. That's because air hockey uses the same principle, with the puck floating on a layer of air. In the case of an air hockey table, the air is forced out from the table below rather than a source above like a hovercraft. Try pushing a plain CD across the table, and then your hovercraft. Do the two move differently? That's because the thin cushion of air from the hovercraft reduces the friction between the CD and the table. Because of the reduced friction, hovercrafts can reach higher speeds.

      Experiment ideas:

      • Test to see if your hovercraft works differently if you open the cap only part way instead of all the way.
      • Try different sizes of balloons. Does the hovercraft run longer on a larger balloon?
      • Hovercrafts work best on smooth surfaces so the air can spread evenly, but experiment with yours on several different surfaces to see how it behaves. Does it work on a sidewalk or carpet?

    « Previous Article: How to Make a Rubber Band Car

    Next Article: Backyard Science »

    « Previous Article: Learn About Beetles

    Next Article: Backyard Science Worksheet »


    By: Zee
    Date: Mar 01, 2017

    Can anyone tell me what to use instead of pop top caps? I need it for a stem night. I don’t think I can get that many pop tops

    By: Teri
    Date: Mar 04, 2016

    please post pictures of bottle pop top and where to glue it. Step by step will help each one.

    By: Andrew
    Date: Feb 16, 2016

    Will you try to make it go upon water?
    This is a cool and fun Project to work on!

    By: Steph
    Date: Oct 08, 2015

    How could you Change your design for a heavier cargo

    By: zamorah
    Date: Sep 17, 2015

    This is pretty fantastic

    By: shree sonar
    Date: Aug 13, 2015

    Hi, can anyone please tell me how can I open pop top cap whereas , balloon is on it.

    [HST adds:  Be sure to hold both parts of the cap when you open it to avoid pulling it off of the cd.  You may want to ask your helper to hold the neck of the balloon so it doesn’t start releasing air until you are ready.  Hope this helps!]

    By: anu
    Date: Jun 26, 2015

    I am trying and i think i can achieve it by getting the prize.

    By: christopher
    Date: Apr 23, 2015

    I like the balloon hovercraft

    By: panxho_bruhh
    Date: Apr 15, 2015

    does it go up or does it do a straight line

    By: corwin
    Date: Mar 03, 2015

    Do you have to use the glue gun?